TL 시리즈 Led Tri-Proof 조명

LED Tri-proof Light products

LED Tri-proof light factory more than 10 years professional in manufacturing linear light fixtures.

LED tri proof light made by special protective materials. It is Waterproof, Dustproof , Corrosion-Proof , and Explosionproof , and protection rating is IP65.

The front cover of the lamp is used of Fireproof PC material with 94 V2 perfect impact-resistance, good toughness.

Can be bent by 180 degree without crack, people can step on it , without any crack. And are good at corrosion-proof. The fireproof rating is V0.

The back cover of the lamp is used of the same Fireproof PC material as the front cover. Silicon rubber sealing frame , make sure perfect seal .

Exclusive quick-fit design batten light 40w 50w, Replaces 2x36W/72W fluorescent batten

Energy efficient – saves up to 60% compared to fluoro batten. Exclusive Quick-Fit design for faster installation

Unique two part batten with quick release connectorsFast installation and easy access for any future maintenance.

LED Tri-Proof Light factory use High efficiency SMD2835 and TUV driver

PC cover with transparent, strip, frosted for options, Transmittance: transparent 93%, strip 90%, frosted 83%.

130lm/w 150lm/w are available, TUV 비 깜박임 드라이버, is very high quality and cost performance, customer feedback is very good.

LED Batten Light available optional

Emergency pack up: 18650 리튬 배터리 1.5 또는 3 hours emergency time

Microwave sensor dim 0%, 25% ,100%-25%-0%; Sensor range 0.5-10M, Sensing time 10s-5min

CE RoHS IP65 tri-proof 2ft 4ft 5ft 20w 40w 50w for parking lot, industrial, 창고, hosiptal, School, 터널, restroom, 복도, basement, food processing plant.

50,000 hours service life with 5 1년 보증.

Touchless mode of LED Lamp

올인원

LED Tri-proof Light

More than just a revolution in installation and maintainance

Tri proof Light Datasheet

LED Tri proof Light Installation

a) Ceiling Mounted: Fix base section of the batten to the ceiling, Connect the AC power cable to the terminal block, either through the top or via the end cap.

b) Hanging Installation: Connect the LED module to the base section with the two wire ropes to support the weight, Join the ends of the internal power cable together

Lock the two halves together, match diffused led module together with gear tray base and then lock the clips to secure the batten